This is done in Device Manager and is a step often missed. #Duckdns teamviewer wake on lan softwareOr it may be under ALLOW POWER UP BY PCI/PCI-X CARD.Īfter booting into Windows we must then make sure that the software is set up to receive a magic packet and enable remote powering. This could be simple ENABLE WAKE ON LAN switch. This walk-through was written using the D-Link DIR-855 but I have now switched to the CISCO E4200 and added the relevant screen shots and information below.įirst you need to go into your computer BIOS and make sure it will accept remote power wake up to your LAN card.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |